Chorus

Affects the frequency range of the modulation sweep by adjusting the initial delay time.

Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.

Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

If Tempo Sync is activated, Rate allows you to specify the base note value for synchronizing the modulation sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).

If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.

Activates/Deactivates tempo sync.

Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.

Allow you to roll off low and high frequencies of the effect signal.