Phaser
This plug-in produces the well-known swooshing phasing effect with additional stereo enhancement.
|
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
|
|---|---|---|---|---|---|---|
|
Included with |
X |
X |
X |
X |
X |
X |
|
Side-chain support |
– |
– |
– |
X |
X |
X |
- Rate
If tempo sync is activated, this is where you specify the base note value for tempo-syncing the phaser sweep (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the sweep rate can be set freely with the Rate knob.
- Sync
Activates/Deactivates tempo sync.
- Width
Sets the intensity of the modulation effect between higher and lower frequencies.
- Feedback
Determines the character of the phaser effect. Higher settings produce a more pronounced effect.
- Spatial
If you are using multi-channel audio, the Spatial parameter creates a 3-dimensional impression by delaying modulation in each channel.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.
- Manual
If this option is activated, the flanger sweep is static, that is, no modulation takes place.
- Filter Lo/Hi
Allow you to roll off low and high frequencies of the effect signal.
If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the Operation Manual.