Flanger
This is a classic flanger effect with added stereo enhancement.
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
NEK |
|
|---|---|---|---|---|---|---|---|
Included with |
X |
X |
X |
X |
X |
X |
– |
Side-chain support |
– |
– |
– |
X |
X |
X |
– |
- Rate
If tempo sync is activated, this is where you specify the base note value for synchronizing the flanger sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the sweep rate can be set freely with the Rate knob.
- Sync
Activates/Deactivates tempo sync.
- Range Lo/Hi
Set the frequency boundaries for the flanger sweep.
- Feedback
Determines the character of the flanger effect. Higher settings produce a more metallic sounding sweep.
- Spatial
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.
- Waveform Shape selector
Allows you to select the modulation waveform, altering the character of the flanger sweep. A sine and a triangle waveform are available.
- Delay
Affects the frequency range of the modulation sweep by adjusting the initial delay time.
- Manual
If this option is activated, the flanger sweep is static, that is, no modulation takes place.
- Filter Lo/Hi
Allow you to roll off low and high frequencies of the effect signal.
If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the Operation Manual.