Lengthening/Shortening segments in repeat endings

You can increase/decrease the number of bars included in each segment of repeat endings by lengthening/shortening each segment independently.

Procedure

  1. In Write mode, select the repeat ending you want to lengthen/shorten.
    Note

    You can only lengthen/shorten one repeat ending segment at a time.

  2. Select the circular handle at the end of the segment you want to lengthen/shorten.

    Figure: The selected handle in the middle has a thicker line.

  3. Click and drag the handle to the right/left to snap it to the next/previous barline.
    Note

    Segments must contain at least one bar.

  4. Optional: Repeat steps 1 to 3 for each segment in the repeat ending.

Result

The selected segment is lengthened/shortened.

Note

This does not automatically input or reposition repeat barlines. You must input repeat barlines as appropriate manually.

Tip

You can also lengthen/shorten the final segment in a single repeat ending by selecting the repeat ending and using the following key commands:

  • Press Shift-Alt-Right Arrow to lengthen the final segment.

  • Press Shift-Alt-Left Arrow to shorten the final segment.