Changing the shoulder offset of ties

You can change the shoulder offset of individual ties, independently of your project-wide settings. For example, you might want to change the shoulder offset of a few very short or very long ties in your project to improve their shape.

Procedure

  1. In Engrave mode, select one of the control point handles on each of the ties whose shoulders you want to adjust in any of the following ways:

    • Select a whole tie and press Tab to cycle through the handles until the one you want to move is selected.

    • Click the handle you want to move.

    • Ctrl/Cmd-click individual handles on multiple ties.

    Tip

    You can show handles on all items, not just selected items, by choosing Engrave > Show Handles > Always. This can make it easier to select individual handles on multiple items.

  2. Move the handles in any of the following ways:

    • Press Alt-Right Arrow to move them to the right.

    • Press Alt-Left Arrow to move them to the left.

    • Press Alt-Up Arrow to move them upwards.

    • Press Alt-Down Arrow to move them downwards.

      Tip

      If you want to move handles by larger increments, you can press Ctrl/Cmd as well as the standard key command, for example, Ctrl/Cmd-Alt-Left Arrow.

    • Click and drag them in any direction.

  3. Optional: Repeat steps 1 and 2 for the other control point handle on the ties whose shoulders you want to adjust.

Result

Moving tie offset handles further apart reduces the shoulder offset, while moving them closer together increases the shoulder offset.

Tip

The following properties in the Ties group of the Properties panel are activated automatically when you move the corresponding tie handles:

  • Start handle offset moves the left control points of ties. X moves them horizontally, Y moves them vertically.

  • End handle offset moves the right control points of ties. X moves them horizontally, Y moves them vertically.

You can also use these properties to change the shoulder offset of individual ties by changing the values in the value fields.

Deactivating the properties resets the corresponding handles on the selected ties to their default positions.

Tip

You can find options controlling the default shoulder offset of all ties project-wide by clicking Advanced Options in the Design section of the Ties page in Engrave > Engraving Options. There are separate settings for short ties and long ties.