Changing the placement of slash region counts relative to the staff

You can change whether counts on individual slash regions appear above or below the staff, independently of your project-wide setting.
Note

Changing the placement of slash region counts relative to the staff affects all counts on the region. You cannot change the placement of a single count independently of other counts on the same slash region.

Procedure

  1. Select any part of each slash region whose count staff-relative placement you want to change.
  2. In the Properties panel, activate Count position in the Slash Regions group.
  3. Choose one of the following options:

    • Above

    • Below

Result

The placement of all counts relative to the staff on the selected slash regions is changed.

Tip

You can change the default placement of all slash region counts project-wide in the Rhythmic slashes section of the Notes page in Engrave > Engraving Options.