Vintage Ensemble

This effect emulates the sound of classic ensemble modulation effects. It is based on a delay with LFO-modulated delay times. A secondary LFO with higher frequencies is used to produce the so-called shimmer.

Rate: Sets the frequency of the LFO.
Sync: If Sync is activated, you can set the Rate value in fractions of beats.
Depth: Sets the intensity of the delay time modulation by the LFO.
Shimmer: Sets the intensity of a secondary faster delay time modulation.
Shimmer Rate: Determines the relation between the speed of the primary and the secondary delay modulation. For example, with a value of 10, the secondary modulation is 10 times faster.
Low Cut: Applies a low-cut filter to the signal. Only frequencies above the set frequency are sent to the effect.
High Cut: Applies a high-cut filter to the signal. Only frequencies below the set frequency are sent to the effect.
FX Level: Allows you to adapt the effect signal level to compensate for level reductions caused by the low-cut and high-cut filters.
Mix: Sets the ratio between the dry and the wet signal.