Using the Insert Effect Slots

On the Effects page, you can set up insert effects for AUX busses.

Each bus provides four slots for insert effects.

• To assign an insert effect, click the effect slot and select the effect from the menu.

• To remove an insert effect including its current settings, click the effect slot and select None from the menu.

• To deactivate an effect without removing it, click its On/Off button above the slot. This way, you can switch off the effect without losing its settings.

• To bypass an effect, activate the Bypass button of the slot. Bypass is active when the button lights up.

• To edit an insert effect, click the e button of the corresponding slot. You can edit only one effect at a time. The parameters of the insert effect are displayed in the bottom section.

• To move an effect to another slot, click its drag icon and drag it to another slot. This replaces any effect loaded in this slot.

• To change the order of the effects, drag them by their drag icon to a new position between two slots.

• To copy an effect into another slot, Alt-click its drag icon and drag it onto the new slot. This replaces any effect loaded in this slot.

  Note

  You can also copy effects between the different mixers. First drag an effect to the corresponding mixer tab. Then drag it to the position where you want to insert it.

• To copy an effect and insert it between two effect slots, Alt-click its drag icon and drag it between two slots.

  Note

  You can also copy effects between the different mixers. First drag an effect to the corresponding mixer tab. Then drag it to the position where you want to insert it.