Transport

Allows you to use Space on your keyboard to start/stop local playback of the selected file in the Sample Editor or the Pool.

When the Sample Editor is not open or when there is no audio file selected in the Pool, Space still toggles the global project playback.

Shows subframes for all frame-based display formats.

You can enter a timecode value on the Transport panel. If you press Shift-P, a specific timecode position is focused. Select one of the following options:

• Full Timecode

  Allows you to enter the timecode as a sequence of numbers. For example, entering 010203 results in 00:01:02:03.

• Starting at Hour Position

  Allows you to enter the timecode per entry field, starting with hours.

• Starting at Minute Position

  Allows you to enter the timecode per entry field, starting with minutes.

Always starts time displays and rulers in Feet+Frames format with 0’00 at the beginning of the project regardless of any offset settings in the Project Setup dialog.

Allows you to set the frame rate for the ruler display format User.

Automatically sets the project cursor to the position where recording or playback last started when you stop playback.

Stops playback when you click Rewind or Fast Forward on the Transport panel.

These options affect the fast forward/rewind speed.

• Adjust to Zoom adapts the wind speed to the horizontal zoom factor.

  If you zoom in very close for detailed editing, you probably do not want to have a high fast forward/rewind speed. Because of this, the Speed Factor does not have any effect in this mode. The Fast Wind Factor still applies.

• Fixed keeps a fixed wind speed regardless of the horizontal zoom factor.

• Speed Factor allows you to set the wind speed. You can set a value between 2 and 50. The higher the value, the faster the wind speed will be.

  If Adjust to Zoom is activated, this has no effect.

• Fast Wind Factor allows you to set the winding speed to a multiple for fast winding.

  If you press Shift while fast forwarding or rewinding, the wind speed will increase. The increase in speed is a multiple of the Speed Factor. Meaning that if you set the Fast Wind Factor to 2, the wind speed will be twice as fast. If you set it to 4, the wind speed will be 4 times as fast, etc. You can set a value between 2 and 50.

Adjusts the width of the project cursor line.

Allows you to zoom in or out by clicking in the ruler and dragging down or up.

Allows you to activate/deactivate cycle mode when you click the locator range in the upper part of the ruler.

Allows you to move the project cursor by clicking in an empty area of the Project window.