ADR Panel
The ADR panel is located in the lower part of the Markers window.
To open the ADR panel, select .
Locate Previous/Next Marker in Markers Window
Allows you to select the previous/next marker in the marker list. If Cycle follows when locating to Markers is activated in the Marker Settings, the corresponding locator range is also selected in the Project window ruler.
Pre-Roll On/Off
Allows you to activate/deactivate a pre-roll for the Free Run Mode.
Free Run Mode On/Off
Activate this mode to start from the project cursor position. On stop, the cursor returns to the start position by default. You can change this by deactivating Return to Start Position on Stop in the Preferences dialog (Transport page).
Deactivate this mode to use the selected cycle marker. Pre-roll and post-roll are determined by the settings on the General tab in the ADR Setup window.
Rehearse
Plays back the selected take so that the artist can rehearse it.
Record
Records the selected take on the record-enabled track.
Review
Plays back the take for review. To enable this, on the Signal Switchboard tab, activate Take in Review mode for Other Audio for the Control Room and Cue 1.
Guide Track for Cue 1 On/Off
Allows you to mute the guide track for cue 1.
Guide Track for Control Room On/Off
Allows you to mute the guide track for the Control Room.
Setup
Allows you to open the ADR Setup window.
Marker Settings
Allows you to show the marker settings.
Show ADR Panel
Allows you to show/hide the ADR panel.
Show Details View
Allows you to show/hide the details view.