PingPongDelay
This is a stereo delay effect that alternates each delay repeat between the left and right channels. The delay line uses tempo-based or freely specified delay time settings.
This plug-in works only on stereo tracks.
- Lo Filter
Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
- Hi Filter
Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.
- Delay
-
Sets the delay time in milliseconds.
- Sync
Activates/Deactivates tempo sync.
- Feedback
Sets the amount of the signal that is sent back into the delay input. The higher this value, the higher the number of repeats.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.
- Spatial
-
Sets the stereo width for the left/right repeats. Turn clockwise for a more pronounced stereo ping-pong effect.
- Start Left/Start Right
-
Determines whether the delay repeat starts on the left or the right channel.
This plug-in supports external side-chaining. You can use the side-chain input to control the delay from another signal source. If the side-chain signal exceeds the threshold, the delay repeats are silenced. If the signal drops below the threshold, the delay repeats reappear. For a description of how to set up side-chain routing, see the “Operation Manual”.