Process Tab
Level
- Gain
-
Opens the Gain dialog where you can apply a gain to change the level of an audio file.
- Envelope
-
Opens the Envelope dialog where you can create a level envelope which can be applied to a selected range or an entire audio file.
This is useful if you want to even out loud and quiet parts or create a sophisticated fade in/fade out, for example.
- Remove DC Offset
-
DC offset in a file affects the loudness. Remove DC Offset sets the DC offset to zero.
Normalizing
- Level
-
Opens the Level Normalizer dialog where you can change the peak level of an audio file.
Fading
- Fade In/Fade Out
-
Allows you to apply a fade in or fade out. Right-click the button to open the Curve pop-up menu.
- Curve
-
Allows you to select preset fade curves.
-
Linear changes the level linearly.
-
Sinus (*) changes the level according to a sine curve. When used in a crossfade, the loudness (RMS) remains constant during the transition.
-
Square-Root (*) changes the level according to a square-root curve. When used in a crossfade, the loudness (RMS) remains constant during the transition.
-
Sinusoid changes the level according to a sine curve.
-
Logarithmic changes the level according to a logarithmic curve.
-
Exponential changes the level according to an exponential curve.
-
Exponential+ changes the level according to a more pronounced exponential curve.
-
Time & Pitch
- Time Stretching
-
Opens the Time Stretching dialog where you can change the duration of an audio selection.
- Pitch Shifting
-
Opens the Pitch Shifting dialog where can change the pitch of your audio.
- Resample
-
Opens the Sample Rate dialog where you can change the sample rate of your audio.
- Pitch Bend
-
Opens the Pitch Bend dialog where you can gradually change the pitch of your audio using an envelope curve.
- Reverse
-
Creates a backwards-tape effect.
Correct
- Error Correction
-
Lets you select the default error correction method.
-
Linear Interpolation draws a straight line between the first and the last selected samples.
-
Optimal for Small Clicks – 1 ms is optimal to remove clicks smaller than 1 ms.
-
Optimal for Common Clicks – 3 ms is optimal to remove clicks smaller than 3 ms.
-
Waveform Replacement – 500 ms replaces the corrupt samples with the best match detected in the material up to 500 milliseconds to the left/right.
-
Waveform Replacement – 4 s replaces the corrupt samples with the best match detected in the material up to 4 seconds to the left/right.
-
Waveform Replacement – Left 6 s replaces the corrupt samples with the best match detected in the material up to 6 seconds to the left.
-
Waveform Replacement – Right 6 s replaces the corrupt samples with the best match detected in the material up to 6 seconds to the right.
-
Loop
- Tweaker
-
Opens the Loop Tweaker dialog where you can adjust the loop start and end points, and crossfade the loop boundaries.
- Tone Uniformizer
-
Opens the Loop Tone Uniformizer dialog where you can create loops from sounds that are not optimal for looping.
Analysis
- Global Analysis
-
Opens the Global Analysis dialog where you can analyze peaks, loudness, pitch, DC offset, and errors in the audio file.
Other
- Invert Phase
-
Turns the signal upside down.