Distroyer
Distroyer adds harmonics to the spectrum and allows for distortion effects from smooth overdrive to extreme clipping.
The following parameters influence only the wet signal:
- Lo Filter
-
Changes the cuttoff frequency of the low-pass filter that is applied to the wet signal before it gets distorted.
- Hi Filter
-
Changes the cuttoff frequency of the high-pass filter that is applied to the already distorted wet signal.
- Offset
-
Modifies the symmetry of the distortion effect by changing the operation point of the characteristic.
- Drive
-
Changes the characteristic of the distortion effect. Lower values lead to a smooth overdrive-like effect. Higher values change the shape of the signal towards a rectangle, leading to extreme distortion.
- Oversampling
-
Activates/Deactivates oversampling. Oversampling results in less artifacts for higher distortion.
NoteIf this parameter is activated, the effect requires more processing power.
- Spatial
-
Changes the distortion characteristics of the left and right channels, thus creating a stereo effect.
- DC Filter
-
Removes DC offset that occurs when using high Offset values.
The following parameters influence both the dry and the wet signal:
- Boost
-
Increases the distortion amount.
- Mix
-
Sets the level balance between dry and wet signal.
- Shelf Freq
-
Sets the frequency of the high shelving filter.
- Shelf Gain
-
Sets the gain of the high shelving filter.
- Tone
-
Sets the frequency of the output low-pass filter.
- Output
-
Sets the output level.