StereoDelay
StereoDelay has two independent delay lines which either use tempo-based or freely specified delay time settings.
This plug-in works only on stereo tracks.
- Feedback
-
Set the number of repeats for each delay.
- Delay
-
Sets the delay time in milliseconds.
- Sync
-
Activates/Deactivates tempo sync for the corresponding delay.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.
- Lo Filter
Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
- Pan
-
Sets the stereo position.
- Hi Filter
Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.
This plug-in supports external side-chaining. You can use the side-chain input to control the delay from another signal source. If the side-chain signal exceeds the threshold, the delay repeats are silenced. If the signal drops below the threshold, the delay repeats reappear. For a description of how to set up side-chain routing, see the Operation Manual.