MonoDelay

This is a mono delay effect. The delay line uses tempo-based or freely specified delay time settings.

Lo Filter: Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the control activates/deactivates the filter.
Hi Filter: Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the control activates/deactivates the filter.
Delay: Sets the delay time in milliseconds.
Sync: Activates/Deactivates tempo sync.
Feedback: Sets the amount of the signal that is sent back into the delay input. The higher this value, the higher the number of repeats.
Mix: Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.