Tube Compressor
This versatile compressor with integrated tube-simulation allows you to achieve smooth and warm compression effects. The VU meter shows the amount of gain reduction. Tube Compressor features an internal side-chain section that lets you filter the trigger signal.
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
NEK |
|
|---|---|---|---|---|---|---|---|
Included with |
– |
– |
X |
X |
X |
X |
– |
Side-chain support |
– |
– |
– |
X |
X |
X |
– |
- Drive (1.0 to 6.0)
Controls the amount of tube saturation.
- Input
Determines the compression amount. The higher the input gain, the more compression is applied.
- Limit
Increases the ratio of the compressor for a limiting effect.
- Output (-12 to 12 dB)
Sets the output gain.
- Attack (0.1 to 100 ms)
Determines how fast the compressor responds. If the attack time is long, more of the initial part of the signal passes through unprocessed.
- Release (10 to 1000 ms or Auto mode)
Sets the time after which the gain returns to its original level. If the Auto button is activated, the plug-in automatically finds the best release setting for the audio material.
- Mix
Adjusts the mix between dry signal and wet signal preserving the transients of the input signal.
- In/Out Meters
Show the highest peaks of all available input and output channels.
- VU Meter
Shows the amount of gain reduction.
- Side-Chain
Activates the internal side-chain filter. The input signal can then be shaped according to the filter parameters. Internal side-chaining is useful for tailoring how the gate operates.
- Filter buttons (LP, BP, and HP)
If the Side-Chain button is activated, you can use these buttons to set the filter type to low-pass, band-pass, or high-pass.
Side-chain section
- Center (50 to 20000 Hz)
If the Side-Chain button is activated, this sets the center frequency of the filter.
- Q-Factor
If the Side-Chain button is activated, this sets the resonance or width of the filter.
- Monitor
Allows you to monitor the filtered signal.