Selecting graphic slice handles
You can select an individual handle on a graphic slice, and you can switch between having a handle selected and having the whole graphic slice selected.
Prerequisite
Graphic Slices is selected in the Engrave toolbox.
Procedure
-
Select a graphic slice handle in any of the following ways:
-
Select any handle on the graphic slice and press Right Arrow/Left Arrow/Up Arrow/Down Arrow to select other handles around its edge.
-
Select the graphic slice, press Tab to switch to having the handle in the top left corner selected, then press Right Arrow/Left Arrow/Up Arrow/Down Arrow to select other handles around the edge of the graphic slice.
-
Click a handle on the graphic slice.
NoteYou can only select a single handle on a single graphic slice at a time.
-
- Optional: To switch back to having the whole graphic slice selected, press Tab.