Automation Page
To access this page, open the Options page and activate the Automation tab at the top.
With the tabs at the top of the Automation page, you can specify whether you want to show the automation parameters for the kit, the global parameters, or all automation parameters.
On the left, the name of the automation parameter is shown, and on the right, the name of the assigned Groove Agent parameter is displayed. If multiple Groove Agent parameters are assigned to one automation parameter, these are listed below each other on the right.
-
To remove an automation parameter, click the trash icon to the right of the parameter name.
-
To remove all automation parameters, click Delete All Parameters at the top of the page.
-
To rename an automation parameter, double-click the parameter name, and enter the new name. This name is then used in your host application.
-
To replace the names for all automation parameters with the names of the pads, click Refresh All Parameter Names on the toolbar.