MultibandEnvelopeShaper

Frequency Band Editor

The frequency band editor in the upper half of the panel is where you set the width of the frequency bands as well as their level. The vertical value scale to the left shows the gain level of each frequency band. The horizontal scale shows the available frequency range.

• To define the frequency range of the different frequency bands, use the handles at the sides of each frequency band.

• To attenuate or boost the gain of the frequency band, use the handles at the top of each frequency band.

Live

If this button is activated, the look-ahead feature of the effect is deactivated. Look-ahead produces more accurate processing, but adds a specific amount of latency as a trade-off. If Live mode is activated, there is no latency, which is better for live processing.

Bypassing Frequency Bands

To bypass each frequency band, activate the Bypass Band button in each section.

Soloing Frequency Bands

To solo a frequency band, activate the S button in each section. Only one band can be soloed at a time.

Output (-24 to 24 dB)

Sets the output level.

Shaper Section

You can specify the Attack, Length, and Release by moving breakpoints or using the corresponding knobs. Be careful with levels when boosting the gain. You can reduce the output level to avoid clipping.

Attack (-20 to 20 dB)

Sets the gain of the attack phase of the signal.

Length (5 to 200 ms)

Sets the length of the attack phase.

Release

Sets the gain of the release phase of the signal.

Sensitivity (-40 to -10 dB)

Sets the sensitivity of the detection.

Output

Sets the output level.