Moving Loop Points Manually

If your loop still has glitches or bumps at the transition points, you can use the Loop Tweaker tool to move the points in small steps to remove the glitch.

This is similar to moving the loop points in the wave display, but with a visual feedback to facilitate finding good loop points.

There are two ways of moving the loop points manually on the Loop Points Adjustment tab in the Loop Tweaker dialog:

• Drag the waveform to the left and right.

• Use the green arrows below the waveform to nudge the audio to the left and right. Each click moves the loop point by a single sample.

The following applies when moving the loop points manually:

• To move the end point to a later or earlier position, move the left part of the display.

• To move the start point to a later or earlier position, move the right part of the display.

• To move the start and end points simultaneously, activate Link Start and End Points. This way, when adjusting a loop point, the length of the loop stays the same, but the entire loop is moved.

• You can also adjust the loop markers in the wave window.