Chorus
This plug-in is a single-stage chorus effect. It doubles the audio that is sent into it with a slightly detuned version.
- Delay
-
Affects the frequency range of the modulation sweep by adjusting the initial delay time.
- Width
-
Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.
- Spatial
-
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
- Mix
-
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.
- Rate
-
If Tempo Sync is activated, Rate allows you to specify the base note value for synchronizing the modulation sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).
If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.
- Sync
-
Activates/Deactivates tempo sync.
- Waveform Shape
-
Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.
- Lo Filter/Hi Filter
-
Allow you to roll off low and high frequencies of the effect signal.