Changing the bar repeat count appearance
You can show individual bar repeat counts with or without parentheses, or not show any repeat count at all, independently of your project-wide setting.
Note
Bar repeat counts are only shown on one-bar repeat regions.
Procedure
- Select the one-bar repeats whose count appearance you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Count appearance in the Bar Repeat Regions group.
-
Select one of the following options from the menu:
-
Parenthesized
-
No parentheses
-
Don’t show
-
Result
The appearance of counts on the selected bar repeat regions is changed.
Tip
You can also change the default appearance of all bar repeat counts project-wide on the Bar Repeats page in .