Changing the size of gaps in dashed/dotted slurs
You can change the length of gaps in dashed/dotted slurs individually, independently of your project-wide settings.
Procedure
- In Engrave mode, select the dashed/dotted slurs whose gap length you want to change.
-
In the Properties panel, activate one of the following properties in the Slurs group:
-
For dashed slurs, activate Dash gap length.
-
For dotted slurs, activate Dot gap length.
-
- Change the values in the value fields.
Result
Increasing the values makes the gaps between dashes/dots larger. Decreasing the values makes the gaps between dashes/dots smaller.
Tip
You can find options to set the default length of the gaps between dashes/dots in all dashed/dotted slurs project-wide by clicking Advanced Options in the Design section of the Slurs page in .