Channel Parameters
The channel strips in the mixer contain a set of parameters. Some channel strips, such as the Room and Overhead channel strips, have additional controls.
- Level
-
Adjusts the volume of the channel.
- Pan
-
Defines the position of the sound in the stereo panorama.
- Mute
-
Mutes the channel.
- Solo
-
Soloes the channel and mutes all other channels. Several channels can be soloed at the same time.
- Peak Level
-
Indicates the highest level on the bus.
-
To reset the peak level, click the text field.
-
- AUX Sends 1-4
-
Use these controls to send the signal to the corresponding AUX busses of the agent.
- Output
-
By default, the output of the Agent mixer busses is routed to the Kit Mix, but you can also assign the busses to one of the plug-in outputs and to the AUX FX 1 to 4.
-
Click the Output field to open the pop-up menu with the available outputs.
-
- Width (Room and Overhead channel strips only)
-
Adjusts the stereo width of the signal from mono to stereo.
- Room Channel On/Off (Room channel strip only)
-
Kits from the “The Kit ” content set have an On/Off button below the Mute button that allows you to deactivate the Room channel and unload its samples from memory. This reduces the processor load.
- Reverb Channel On/Off (Reverb channel strip only)
-
The On/Off button below the Mute button allows you to deactivate the Reverb channel and unload its samples from memory. This way, you can reduce the processor load if you do not want to apply the reverb effect to the Kit Mix.