Sat

Determines the amount of saturation and the generation of overtones. This leads to a small increase in input gain.

Simulates the use of two tape machines.

Activates/Deactivates the saturation effect.

Allows you to adjust the output level.

Indicates the amount of saturation of the signal.

Sets the frequency range of the spectrum band to which the tape effect is applied.

To avoid the saturation of lower frequencies, set the value to 200 Hz or 300 Hz.

Sets the frequency range of the spectrum band to which the tape effect is applied.

To avoid the saturation of very high frequencies, set the Freq Hi parameter to values below 10 kHz.

Allows you to hear only the set frequency range including the tape simulation effect. This helps you to determine the appropriate frequency range.

Sets the amount of high frequency content of the saturated signal.

Activates/Deactivates the HF-Adjust filter.

Controls the amount of tape saturation.

Simulates the use of two tape machines.

Adjusts the gain automatically.

Sets the output gain.

Indicates the amount of drive of the signal.

This is a low shelving filter with fixed frequency.

This is a Hi Cut filter. Use the frequency fader to reduce harshness of the output signal.

Controls the amount of tube saturation.

Sets the output gain.

Indicates the amount of drive of the signal.

This is a low shelving filter with fixed frequency.

This is a Hi Cut filter. Use the frequency fader to reduce harshness.