Logical Editor Filter Conditions
Depending on the Filter Target setting, the following options can be selected in the Condition column:
- Equal
-
Has the same value as set up in the Parameter 1 column.
- Unequal
-
Has any value other than the one set up in the Parameter 1 column.
- Bigger
-
Has a value higher than the one set up in the Parameter 1 column.
- Bigger or Equal
-
Has a value that is the same as or higher than the one set up in the Parameter 1 column.
- Less
-
Has a value lower than the one set up in the Parameter 1 column.
- Less or Equal
-
Has a value that is the same as or lower than the one set up in the Parameter 1 column.
- Inside Range
-
Has a value that is between the values set up in the Parameter 1 and Parameter 2 columns. Parameter 1 should be the lower value and Parameter 2 the higher.
- Outside Range
-
Has a value that is not between the values set up in the Parameter 1 and Parameter 2 columns.
- Inside Bar Range
-
Has a value that is within the zone set up in the Bar Range/Time Base column, in each bar within the current selection. This is only used if the Filter Target is set to Position.
- Outside Bar Range
-
Has a value outside the zone set up in the Bar Range/Time Base column, in each bar within the current selection. This is only used if the Filter Target is set to Position.
- Before Cursor
-
Is before the cursor position. This is only used if the Filter Target is set to Position.
- Beyond Cursor
-
Is after the cursor position Position only.
- Inside Cycle
-
Is inside the set cycle. This is only used if the Filter Target is set to Position.
- Outside Cycle
-
Is outside the set cycle. This is only used if the Filter Target is set to Position.
- Inside Track Loop
-
Is inside the set track loop. This is only used if the Filter Target is set to Position.
- Exactly Matching Cycle
-
Exactly matches the set cycle. This is only used if the Filter Target is set to Position.
- Inside Selected Marker
-
Is inside the selected cycle marker. This is only used if the Filter Target is set to Position.
- Note is Equal to
-
Is the note specified in the Parameter 1 column only, regardless of octave. For example, lets you find all C notes, in all octaves. This is only available if the Filter Target is set to Value 1, that is, Pitch.
- All Types
-
All event types.
- Property is Set
-
The property specified in the Parameter 1 column is set.
- Property is Not Set
-
The property specified in the Parameter 1 column is not set.
- Every other Event
-
Every x event, where x is the value specified in the Parameter 2 column. This is only used if the Filter Target is set to Last Event, and Parameter 1 is set to Event Counter.
The conditions for the Property filter target are different.