Using Pre-Roll and Post-Roll
You can set up a pre-roll and a post-roll for recording.
Prerequisite
Activate Stop after Automatic Punch Out in the Preferences dialog (Record page).
Procedure
- Set the locators to where you want to start and end recording.
- On the Transport panel, activate Punch In and Punch Out.
- Activate Pre-roll and Post-roll.
- Specify a Pre-roll Amount and a Post-roll Amount.
- Click Record.
Result
The project cursor rolls back and starts playback at the time that has been set as pre-roll amount. When the cursor reaches the left locator, recording is automatically activated. When the cursor reaches the right locator, recording is deactivated, and playback continues for the time that has been set as post-roll amount.