Select Menu
Select Pop-Up Menu in the Range Section
On the Select pop-up menu in the Range section of the Sample Editor Inspector, the following functions are available:
- Select All
-
Selects the whole clip.
- Select None
-
Deselects everything.
- Select in Loop
-
Selects the audio between the left and the right locator.
- Select Event
-
Selects only the audio that is included in the edited event. If the VariAudio section is open and you segmented the audio, all segments that start or end within the event boundaries are selected.
- Set Locators to Selection Range
-
Sets the locators to encompass the current selection. This option is available if you have selected one or several events or made a selection range.
- Locate Selection
-
Moves the project cursor to the beginning or to the end of the current selection. This option is available if you have selected one or several events or made a selection range.
- Loop Selection
-
Activates playback from the start of the selection and keeps starting over again at the selection end.
Select Submenu on the Edit Menu
If you select
, the following functions are available:- All
Selects the whole clip.
- None
Deselects everything.
- In Loop
Selects the audio between the left and right locator.
- From Start to Cursor
Selects the audio between the clip start and the project cursor.
- From Cursor to End
Selects the audio between the project cursor and the clip end. This option is available if the project cursor is positioned between the clip boundaries.
- Equal Pitch - all Octaves/same Octave
-
Selects all notes that have the same pitch as the selected note, in any octave or in the current octave. This option is available if the VariAudio section is open and Edit VariAudio is activated.
- Events under Cursor
-
Selects all events that are touched by the project cursor. This option is available if the VariAudio section is open and Edit VariAudio is activated.
- Select Event
-
Selects the event.
- Left Selection Side to Cursor
Moves the left side of the selection range to the project cursor position. This option is available if the project cursor is positioned between the clip boundaries.
- Right Selection Side to Cursor
Moves the right side of the selection range to the project cursor position or the end of the clip, if the project cursor is positioned to the right of the clip.