Hiding/Showing flared ends on hairpins
Flared ends are usually shown at the end of crescendo hairpins and indicate a sudden burst in volume at the end of the crescendo. You can hide/show flared ends on any hairpin.
Note
You can only show flared ends on hairpins with solid lines.
Prerequisite
If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.
Procedure
- Select the hairpins on which you want to hide/show flared ends. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate/deactivate Flared end in the Dynamics group.
Result
A flared end is shown on the selected dynamics when Flared end is activated, and hidden when it is deactivated.