Changing the staff-relative placement of guitar techniques
You can show individual tapping, hammer-on, and pull-off indications either above or below the staff, independently of your project-wide settings.
You can do this for the current layout and frame chain only or for all layouts and frame chains.
Prerequisite
-
If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.
-
You have chosen the appropriate property scope for local properties.
Procedure
- Select the notes whose guitar technique staff-relative placement you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Technique placement in the Guitar Techniques group.
-
Choose one of the following options:
-
Above
-
Below
-
Result
The staff-relative placement of tapping, hammer-on, and pull-off indications on the selected notes is changed. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
-
You can change the staff-relative placement of vibrato bar dips and indications/lines, and the direction of guitar bends on notation staves, by selecting them and pressing F.
-
You can change the default placement of hammer-on and pull-off indications on notation staves and tablature independently on the Guitar Techniques page in .