Loudness Tab (Global Analysis)

Note

To identify sections that the ear perceives as significantly high in terms of volume, you must look at a longer section of audio.

In the Global Analysis dialog, select the Loudness tab.

The following options are available for the RMS Loudness tab and the EBU R-128 tab:

Maximum Number of Loudness Points to Report: Restricts the number of reported hot points. Only the highest points are reported. For example, setting this to 1 reports only the loudest section or one of the sections that have the same highest value.
Minimum Time between 2 Points: Controls the distance between points, so they do not appear too close to each other. For example, setting this to 1 s ensures that two reported peaks are at least one second apart from each other.
Analyze Loudness: Enables the RMS loudness analysis.

RMS Loudness tab

Analyze Loudness: Enables the RMS loudness analysis.
Average: Displays the overall loudness of the analyzed selection.
Maximum: Displays the level of the loudest section in the analyzed selection. Clicking this value displays the number of loud sections detected within the selection in the Number of Points section in the lower left corner of the dialog.
Minimum: Displays the level of the quietest section in the analyzed selection. Clicking this value displays the number of weak sections that are detected within the selection in the Number of Points section in the lower left corner of the dialog. This provides adequate information about the signal-to-noise ratio (SNR) of the audio material.
Around Cursor: Displays the loudness at the audio file cursor position at the time of the analysis.
Resolution: The length of audio to be measured and averaged. If this value is lowered, short passages of loud/weak audio are detected. If the value is raised, the sound must be loud/weak for a longer period to result in a hot point.
Threshold (for the Average): Ensures that the average value is calculated correctly for recordings with pauses. The value that you set here determines a threshold below which any detected audio is considered to be silence, and is therefore excluded from average value calculations.

EBU R-128 tab

Integrated Loudness: Displays the integrated loudness of the analyzed selection, also known as programme loudness, according to the loudness analysis reference value. This indicates the average loudness of the audio.
Loudness Range: Displays the loudness range according to the loudness analysis reference value. It is based on a statistical distribution of loudness within a programme, thereby excluding the extremes.
Short-Term Loudness: Maximum: Displays the level of the loudest 3 second section in the analyzed selection. When you click this value, the number of loud sections that are detected within the selection is shown in the Number of Points section in the lower left corner of the dialog.
Short-Term Loudness: Minimum: Displays the level of the quietest 3 second section in the analyzed selection. When you click this value, the number of quiet sections that are detected within the selection is shown in the Number of Points section in the lower left corner of the dialog. This provides adequate information about the signal-to-noise ratio (SNR) of the audio material.
Momentary Loudness: Maximum: Displays the level of the loudest very short section (400 milliseconds) in the analyzed selection. When you click this value, the number of loud sections that are detected within the selection is shown in the Number of Points section in the lower left corner of the dialog.
Momentary Loudness: Minimum: Displays the level of the quietest very short section (400 milliseconds) in the analyzed selection. When you click this value, the number of quiet sections that are detected within the selection is shown in the Number of Points section in the lower left corner of the dialog.