Stopping Recording

  • To stop recording and playback, click Stop on the Transport panel or use the corresponding key command, by default Num-0.

  • To stop recording and continue playback, click Record or use the corresponding key command, by default Num-*.

  • To stop recording automatically when the project cursor reaches the punch out position and continue playback, activate Punch Out on the Transport panel.

    Note

    If you have unlocked the punch positions from the locator positions, recording is automatically stopped when the project cursor reaches the punch out position.

    Note

    If cycle mode is activated, the punch in point is set after the left locator, and the punch out point corresponds to the right locator, recording is started at the punch in position, stopped at the punch out position, and resumed at the punch in position.