Table of Contents
Setting up Your System
To use Nuendo, you must set up your audio, and if required, your MIDI system.
Setting up Audio
You must set up your audio equipment before you can use it in Nuendo.
Selecting an Audio Driver
By selecting an audio driver, you allow Nuendo to communicate with the audio hardware. Normally, when you start Nuendo, a dialog opens that prompts you to select a driver, but you can also select your audio hardware driver as described below.

Selecting an Audio Driver

By selecting an audio driver, you allow Nuendo to communicate with the audio hardware. Normally, when you start Nuendo, a dialog opens that prompts you to select a driver, but you can also select your audio hardware driver as described below.

Note

On Windows operating systems, we recommend that you access your hardware via an ASIO driver developed specifically for the hardware. If no ASIO driver is installed, contact the manufacturer of your audio hardware for information on available ASIO drivers. If no specific ASIO driver is available, you can use the Generic Low Latency ASIO driver.

Procedure

Select Studio > Studio Setup.
In the Devices list, select Audio System.
Open the ASIO Driver pop-up menu and select your audio hardware driver.
Click OK.